Pages

Wednesday 25 March 2015

Hand-made Coasters Tutorial

Long long ago in the depths of winter, I published this picture on my Facebook Page of these coasters that I'd made:



and at the time promised to write a tutorial on how to make them.  Well, finally here it is - just in time for a bit of Easter Holiday crafting. It's a bit brief so if you need any more detail, then please just get in touch and ask away, and apologies if the photos are a bit dull - they were taken in deepest darkest winter too!  It's a nice project to do with older children, but does require quite a bit of patience and accuracy (Good Luck!)



What you'll need:



- Basic 10x10cm plain tiles (I got mine in Homebase - end of line so really cheap)

- Mod Podge or similar water-based sealer glue with a matt finish.

- Plasti-kote Acrylic Sealer Spray (or similar) I went for matt finish but you could go glossy!

- Decorative Papers - I've tried free decorative/designer paper samples from craft magazines, wrapping paper and thin wallpaper (wallpaper can be a bit thick, something normal paper-weight is fine though) The paper here is a Habitat wallpaper (free sample piece from DIY store!)

- Black felt roll or squares

- Scissors, Pencil, Ruler, Foam Glue Brush.




What you do:

Lay your tiles out onto the paper, centering the part of the design where you want it on the tiles.





Allowing for a 3mm border around each tile, carefully cut out your paper pieces




 Using the foam brush, spread Mod Podge onto wrong-side of paper,



 and firmly press tile to centre, leaving that border around each edge:




 Using sharp scissors, snip off the paper corners at each corner of the tile:




and carefully fold over the edges, pressing down firmly to cover the sides of the tiles:



 Complete process for all 4 tiles (or more if you're making a larger set)




Then, going back to the Modge Podge, paint on a layer of glue over the surface and edges of each tile and leave to dry:


They will look like this when drying.  The drying process can take anything from 30 minutes to a good few hours depending on how thick the glue is, and how warm your room is. It's really important to let the layer really dry fully so some patience is required!




When dry, the glue will be clear - like this:



Repeat the process 2 more times, allowing each layer of glue to properly dry. If you don't, you will get unsightly bubbles on the surface of the coasters.



Once the 3 layers are fully dry, take your set of coasters outside to seal with an acrylic spray.  This spray is pretty potent - full of stinky solvents, so don't let kids do this bit and work outside or with LOADS of ventilation.

Spray each tile with sealer, including the edges, and leave to dry. Repeat with another coat or 2 to ensure the coasters are fully wipe-able.




Once coasters are dry (the smell will soon go!), you need to finish off with the felt backing.
Simply draw around your tile onto the felt sheets and cut out.






 Then apply glue to the underside of each tile either using Modge Podge or if you have a fancy glue gun - use that! Wait to dry (again!)  Sorry - lots of 'waiting to dry' in this project......



 Finally, trim off any excess felt sticking out around the edges to make the coasters nice and neat....




 ...and tah dah! You're done. if you're giving them as a gift, you can tie with ribbon or make some binding as I've done here with kraft paper:



Give it a go. Let me know if my instructions are or aren't any good and enjoy making lots of lovely coasters....you could even print off family photos and use those - great gifts for Grandparents.....makes a change from an Easter Egg.

Bye for now,
Emma xx

Wednesday 11 March 2015

Creative with Kids Series: The Dot

This is just a quick post about a brilliant little book with a brilliantly conveyed big message. I came across it just recently (it was actually published in 2003) when helping T overcome a crisis of confidence over his ability to 'draw'. It's a children's book by American author Peter Reynolds, called 'The Dot'. 



Whilst primarily being a book for kids; it is, like any truly great children's book, also very relevant and engaging for us adults.

I don't want to ruin the story for you by going into too much detail, but it's just the perfect read for anyone, young or old, who thinks they can't do something. It encourages self-discovery, self-expression and a broadening of the concept of  'art'.

Quite apart from the story itself, the charming, whimsical illustrations are simply stunning.

Clearly something he is passionate about, Peter Reynolds gives some further suggestions of activities to capture the creative spirit of children, here on his website.








I love the dedication at the end of the book. How wonderful that Mr Matson was such an inspiration and remains in the author's memory as the adult who encouraged him to 'make his mark'...Exactly what all teachers should be capable of doing.




So, if you or your child have ever said "..but I can't do it", or "I'm rubbish at it", then I urge you to buy this book. Buy it and leave it lying around for everyone to pick up and read.

Righto, I'm off to draw some dots.....
Emma x



p.s If you like The Dot, Peter Reynolds has written 2 follow-up books: 'ish' and 'Sky Colour'. Enjoy!











Thursday 5 March 2015

Paper cuts

Shame on me...I just found this post that I wrote A WHOLE YEAR AGO but didn't get round to publishing. Oh well...Mother's Day has nearly come around again, so here we go...as relevant now as it was 12 months ago!!



Something I've been meaning to get around to for absolutely ages, is having a go at  the art of 'paper cutting'.

I've always much admired the amazing, intricate work of Rob Ryan

*Apologies for the quality of the photos in this post. They were taken whilst I was carrying out the project at about 8pm - so the light is not great.

I purchased this wonderfully clear and concise book and a paper cutting knife almost a year ago and then it sat neglected and lonely on the shelf waiting desperately to be an inspiration and of use.



With Mothers Day coming up, I thought 'ah ha', now is my chance to have a go by making some paper-cut cards for our Mums....and a 'go' it was...(I certainly need to hone my skills where this one is concerned),  but Mums are very forgiving so I knew they'd appreciate the effort rather than the result.

Pressed for time, as usual, I used the templates provided in the book as this was my first attempt and I didn't want to start designing my own artwork without seeing how tricky it might be. I selected and copied these 2 floral designs to then attached to my card. School-girl error on my card selection though - WAY too thick which meant that I had a VERY sore hand when I finished and the edges weren't as crisp and neat as I would have liked. 




So, the process basically involves attaching the template to the card and carefully (very carefully) cutting away the 'empty' areas. You are then left with the design on the card





Find some contrasting card or paper to fix to the back and 'tah-dah', the card is complete.  I added some text by applying clear stickers to the top of the cards, which, in hindsight didn't give a very professional finish but did I mention this was my first attempt?!!






Although far from perfect, I do love the effect that paper cutting produces and because it is all done by hand, even if you are using the same template, each piece is completely unique.  Next up I will have a go at creating my own designs....watch this space.....